Lynx EPM-4 Manuel d'utilisateur télécharger pdf (Page 20)

CMOS Setup / Advanced Configuration

Configuration / Operation – 12 EPM-4 Reference Manual

Usually, the drive you specify here corresponds to the declaration in the Drive

Assignment Order field.

A CD-ROM drive can be inserted into the boot order by selecting “CDROM” at the

desired boot order position.

CMOS Setup / Advanced Configuration

D0000H 64K PAGE FUNCTION

Default: ISA bus

ISA bus

Memory accesses to the D0000h page will be sent to the ISA bus for use by PC/104

expansion modules. This setting is required when flashing the BIOS with the FBU utility.

BIOS Ext

The D0000h page is mapped to sector 1 in the flash chip, which may contain 3

party

Ethernet boot code or any other BIOS extension (not included). If there is a such an

extension present, it will be called by the BIOS. The BIOS extension can be programmed

into the flash chip with the FBU utility. For remote booting via Ethernet, the

recommended boot ROM is Managed PC Boot Agent from Argon Technology

Corporation.

RAM

System RAM is exposed in the D0000h page.

PLD

Default: 0E0h

Specifies the location of the PLD register in I/O space. It can be moved to 1E0h in case of an

address conflict within add-in module.

ORCE ETHERNET 10-BASET

Default: Disabled

When enabled, this will disable the Ethernet media data rate auto-negotiation and force it to 10-

BaseT mode.

Note: Some drivers will put the Ethernet back into auto-negotiation mode.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Pas de commentaire

Lynx EPM-4 Manuel d'utilisateur Page 20